Linux Server Details

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Minor_snmp_Issue ======

= snmp issue in upgrading from sarge to etch =

After upgrading from Debian sarge to etch, there was a problem with snmp on one of my servers. No snmp information could be obtained. Note: this problem only occurred when I upgrade to etch on 10th of April, 2007. A previously upgraded server to etch, a few months previous did not have this problem.

====== Research and Debug ======
 snmpwalk -v 1 -OS -c public localhost
 
 netstat -a
 <nowiki>//</nowiki>check for snmp

The output of netstat showed:

udp        0      0 localhost:snmp                  *:*

So snmp had bound to 127.0.0.1 for some reason. Looking in /etc/snmp/* did not reveal anything.

====== Problem and Solution ======
 ps -eaf | grep snmp
 snmp      8852     1  2 17:01 ?        00:00:00 /usr/sbin/snmpd -Lsd -Lf /dev/null -u snmp -I -smux -p /var/run/snmpd.pid 127.0.0.1

The snmpd had specifically been given a 127.0.0.1 starting parameter.

 vi /etc/default/snmpd
 
 <nowiki>//</nowiki>change the following:
 SNMPDOPTS='-Lsd -Lf /dev/null -u snmp -I -smux -p /var/run/snmpd.pid 127.0.0.1'
 
 <nowiki>//</nowiki>to:
 SNMPDOPTS='-Lsd -Lf /dev/null -u snmp -I -smux -p /var/run/snmpd.pid'

Done. Hope it works. 
The above config to /etc/default/snmpd was done on the original [[Snmpd & mrtg]] setup, however on upgrading, etch must have put a new default/snmpd into /etc/.
Check with "snmpwalk -v 1 -OS -c public localhost" from localhost and/or from your monitoring server.